Multiquip FS3SP Concrete SAW Console Components, Operation hours saw has been in use, Choke

FS3SP CONCRETE SAW — CONSOLE COMPONENTS

Figure 5 displays the location of the various operational control features of the FS3SP saw. Features are dependent on the specific model saw selected. The function of each console component or indicator is explained below:

1.	Engine ON/OFF Switch – Pull the switch to permit engine
	starting. Push the switch to stop engine. Also acts as a fast
	and secure way to stop the engine in an emergency.
2.	Digital Tachometer/Hourmeter – Indicates engine RPM
	and operation hours saw has been in use.

3. Water ON/OFF Valve – On position opens valve and permits water to flow from source through saw water hose. OFF position closes valve and halts the flow of water

	through the saw.
4.	Throttle Lever – Pull the lever to increase engine RPM.
	Push lever to decrease engine RPM (twist handle to lock).
5.	Choke Lever – Pull lever to assist when starting a cold
	engine. Push lever down after engine warms to disengage
	choke.
6.	Blade Raise/lower Switch – Raise position raises blade.
	Lower position lowers blade.

7. Light Switch – On position provdes power to external lights. Off position secures power to external lights.

8. Pump On Switch – On position provides power to external water pump. Off position secures power to external water pump.

9. Raise/Lower Crank Handle – IPhysically orients saw(Raises/Lowers) depending on turn direction and number of turns. Turning the handle "clockwise" lowers the saw, turning the handle "counter-clockwise" raises the saw. (Used in conjunction with the Depth Feed Gauge)

10. Depth Feed Gauge –Indicates the blade cutting depth in inches. To activate, first lower the blade via the crank handle until the blade touches the cutting surface. Then roll the depth feed dial until the face label reads zero.

11. Start Button – A spring loaded button, that when pressed actuates the engine start solenoid.

12. Forward/Reverse Speed Lever – Controls forward and reverse speeds for self-propelled operation. Provides positive neutral for engine start. ALWAYS place transmission engage/disengage lever in the engage position before setting speed lever.

13. Handle Bar Locking Knobs – Loosen or tighten these two knobs when making adjustments to the handlebar(s). Turn handle(s) counter-clockwiseto loosen and clockwise to tighten.

Figure 5. Console Components

PAGE 16 — MQ-WHITEMAN FS3SP CONCRETE SAW — PARTS & OPERATION MANUAL — REV. #0 (07/15/02)