3Com 5108M-TP manual Installing a 10BASE-T Module

1.Set the dip switches on the board to the settings you want, if different than the default values. (Refer to Table 1-2, Table 1-3, Table 1-4, and Table 1-5 for an explanation of the dip switch settings.)

2.Locate a blank slot in the concentrator. If there is no blank slot, you must remove a blank panel on the concentrator to expose a slot for the 10BASE-T Module.

3.Insert the module into the board guides at the top and bottom of the slot and slide it into the concentrator. Makesure the connector is well seated into the backplane of the concentrator.

Figure 3-1 shows the installation of the 10BASE-T Module.

Figure 3-1. Installing a 10BASE-T Module

Installing and Operating the Module 3 - 3