installation

Outdoor Installation

If possible install the generator in a area that is free of debris, bystanders, and overhead obstructions. Make sure the generator is on secure level ground so that it cannot slide or shift around.

The installation site must be relatively free from moisture and dust. All electrical equipment should be protected from excessive moisture. Failure to do will result in deterioration of the insulation and will result in short circuits and grounding.

Foreign materials such as dust, sand, lint and abrasive materials have a tendency to cause excessive wear to engine and alternator parts.

WARNING

Pay close attention to ventilation when operating the generator inside tunnels and caves. The engine exhaust contains noxious elements. Engine exhaust must be routed to a ventilated area

Indoor Installation

Exhaust gases from gas engines are extremely poisonous. Whenever an engine is installed indoors the exhaust fumes must be vented to the outside. The engine should be installed at least two feet from any outside wall. Using an exhaust pipe which is too long or too small can cause excessive back pressure which will cause the engine to heat excessively and possibly burn the valves.

placement

The generator should always be placed on a flat level surface when it is running. DO NOT place the generator on slopes, the possibility exists that the generator could slide.

DANGER

An electric shock is apt to happen when vibrators are used. Pay close attention to handling when operating vibrators and always use rubber boots and gloves to insulate the body from a short circuit.

Generator Grounding

To guard against electrical shock and possible damage to the equipment, it is important to provide a good EARTH ground.

Article 250 (Grounding) of the National Electrical Code (NEC) provides guide lines for proper grounding and specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.

NEC articles 250-64(b) and 250-66 set the following grounding requirements:

1.Use one of the following wire types to connect the generator to earth ground.

a.Copper - 10 AWG (5.3 mm2) or larger.

b.Aluminum - 8 AWG (8.4 mm2) or larger.

2.When grounding the generator (Figure 2) connect the ground cable between the lock washer and the nut on the generator and tighten the nut fully. Connect the other end of the ground cable to earth ground.

3.NEC article 250-52(c) specifies that the earth ground rod should be buried a minimum of 8 ft. into the ground.

NOTICE

When connecting the generator to any buildings electrical system ALWAYS consult with a licensed electrician.

GAC6HZR 60 hz GENERATOR • operation and parts manual — rev. #1 (03/31/10) — page 15

Page 14 Page 16
Page 15
Image 15
Multiquip GAC-6HZR manual Outdoor Installation, Indoor Installation, Placement, Generator Grounding
Page 14 Page 16

GAC-6HZR specifications

The Multiquip GAC-6HZR is a versatile and powerful gasoline generator designed for a wide range of applications, including construction sites, events, and emergency backup power. Built with reliability and performance in mind, this generator is an excellent choice for users seeking a robust power solution.

One of the main features of the GAC-6HZR is its impressive output capacity. With a maximum power output of 6,000 watts and a rated output of 5,500 watts, this generator can handle multiple tools and appliances simultaneously, making it an ideal choice for contractors and outdoor enthusiasts alike. The addition of a reliable Honda GX390 engine ensures optimal performance and fuel efficiency, allowing for extended run times between refueling.

The GAC-6HZR is equipped with an easy-to-read control panel that features multiple 120V and 240V outlets, a circuit breaker, and a gas gauge, providing users with everything they need to manage their power needs efficiently. The inclusion of a 12V DC outlet also allows for charging batteries, further enhancing its usability across different applications.

Safety considerations are paramount in the design of the GAC-6HZR. The generator includes a low-oil shutdown feature that automatically turns off the engine when oil levels drop to a dangerous level, preventing damage and extending the unit's lifespan. Additionally, its sturdy steel frame construction provides durability and protection against harsh environments.

The GAC-6HZR also integrates advanced technologies to enhance its performance and user experience. Its digital ignition system ensures easier starts in various conditions, while its noise-reducing design keeps operation quiet enough for use in residential areas or during events. Furthermore, the generator's compact and portable design, featuring ergonomically designed handles, allows for easy transportation and maneuvering on job sites or around the home.

In conclusion, the Multiquip GAC-6HZR is a powerful and reliable generator that is well-equipped to meet the demands of users in various fields. With its high output, advanced safety features, and user-friendly design, it stands out as a dependable power solution for anyone in need of portable electricity. Whether used for construction, events, or emergency power supply, the GAC-6HZR is designed to deliver exceptional performance and reliability.
Top Page Image Contents