Multiquip GB12BW/BS/BP manual Raising the Mast GB12BW, Always make sure

GLOBUG GB12BW/BS/BP LIGHTING SYSTEM — SETUP (GB12BW)

5.Attach the S-type hook (Figure 15) on the AC power cable onto the washer-eylet located on the bottom plate of the light assembly.

2.To improve stability and to prevent tipping of the light unit, place sand bags or similar type weight over the tripod legs or weight hook as shown in Figure 16.

BOTTOM

PLATE

WASHER

EYELET

S-TYPE

HOOK

Figure 15. Securing Power Cord

Raising the Mast (GB12BW)

1.Before raising the mast, make sure the upper T-handle bolt lock (Figure 16) is securely tightened. This will prevent the balloon/lamp assembly from falling off. In addition make sure that the lamp power cable is connected to the mating end of the 15 ft (4.5 meters) power source cable.

DANGER - Overhead Obstructions

ALWAYS make sure the

area above the lighting system is open and clear of overhead power lines and

other obstructions.The mast extends in excess of 13 ft. (4 meters) when an optional exrension is used. Contact with overhead power lines or

other obstructions could result in equipment damage,

Serious Injury or Death!

UPPER

T-HANDLE

MAST

RAISE LOWER

T-HANDLE

WEIGHT

HOOK

SAND

BAGS

Figure 16. Sand Bags

3.Raise mast to desired height and tighten lower T-handle (Figure 16) securely.

CAUTION - MAST PINCH POINT

When raising or lowering the mast, keep hands and fingers clear of the various mast sections.This will prevent hands and fingers from getting pinched.

DANGER - HIGH VOLTAGE POWER LINES

When raising mast, ALWAYS be on the lookout for overhead obstructions such as high voltage power lines.The possibility exists of electrocution,

even death! if the lighting system comes in contact with high voltage power lines.

PAGE 18 — GLOBUG LIGHTING SYSTEM — OPERATION AND PARTS MANUAL — REV. #2 (11/03/08)