MOONLIGHT LIGHTING SYSTEM — ASSEMBLY
6.Install the winch handle on the mast as shown in Figure 12.
2.Step on the leg lock to release each leg and pull down until it locks in place (see Figure 14).
WINCH HANDLE
Figure 12. Winch Handle Installation
TO PREVENT SERIOUS
INJURY OR DEATH
DANGER!
| ALWAYS MAKE SURE AREA |
| ABOVE MAST IS OPEN |
| AND CLEAR OF OVERHEAD |
| POWER LINES. THE POSSIBILITY |
| EXISTS OF ELECTROCUTION, |
| SHOCK, EVEN DEATH! IF THE |
MAST | BALLOON COMES IN CONTACT |
| WITH HIGH VOLTAGE LINES. |
7.The cart is now ready for the balloon to be installed. Proceed to BALLOON INFLATION section.
MBS STAND ASSEMBLY
If the Moonlight balloon is to be mounted into the MBS Stand, perform the following assembly procedure before installing the balloon.
1.Attach the 4 legs of the stand as shown in Figure 13.
Figure 14. Stand Legs Deployed
3.Slide mast into the stand and and tighten the two nuts as shown in Figure 15.
Figure 15. MBS Mast Installation
Figure 13. Stand Legs Installation
MOONLIGHT LIGHTING SYSTEM — OPERATION & PARTS MANUAL — REV. #0 (10/27/06) — PAGE 17