MOONLIGHT LIGHTING SYSTEM — ASSEMBLY
4.Install the winch handle on the mast as shown in Figure 12.
5.The stand is now ready for the balloon to be installed. Proceed to BALLOON INFLATION section.
MBT TRIPOD ASSEMBLY
The MBT Tripod can be used with the MB150 and MB400 Balloons. The MBT Tripod is shipped
1.To secure the legs in place, loosen the knob (see Figure 17), pull the legs out and tighten the knob.
DANGER!
MAST
TO PREVENT SERIOUS
INJURY OR DEATH
ALWAYS MAKE SURE AREA ABOVE MAST IS OPEN AND CLEAR OF OVERHEAD POWER LINES. THE POSSIBILITY EXISTS OF ELECTROCUTION, SHOCK, EVEN DEATH! IF THE BALLOON COMES IN CONTACT WITH HIGH VOLTAGE LINES.
TWIST KNOB
TO LOCK LEGS
6.When balloon and mast are removed and stored, the MBS stand legs can be stowed as shown in Figure 16.
Figure 17. MBT Tripod Adjustments
DANGER!
POLE
TO PREVENT SERIOUS
INJURY OR DEATH
ALWAYS MAKE SURE AREA ABOVE POLE IS OPEN AND CLEAR OF OVERHEAD POWER LINES. THE POSSIBILITY EXISTS OF ELECTROCUTION, SHOCK, EVEN DEATH! IF THE BALLOON COMES IN CONTACT WITH HIGH VOLTAGE LINES.
Figure 16. Stand Legs Stored | 2. The tripod is now ready for the balloon to be installed. |
| Proceed to BALLOON INFLATION section. |
PAGE 18 — MOONLIGHT LIGHTING SYSTEM — OPERATION & PARTS MANUAL — REV. #0 (10/27/06)
