Cast Iron Stove And B-Vent Burner System Assembly, Continued

PRE-INSTALLATION PREPARATION

Location and Space Requirements (Cont.)

CAST IRON STOVE AND B-VENT BURNER SYSTEM ASSEMBLY

Stove Body Assembly

PRE-INSTALLATION PREPARATION

Continued

4" 4"

Figure 4 - Clearance for Corner Installation

26 1/4"

Front

19 1/2"

Figure 5 - Stove With Burner System Bottom Dimensions

CAST IRON STOVE AND B-VENT BURNER SYSTEM ASSEMBLY

STOVE BODY ASSEMBLY

1.Lift off corrugated box enclosing stove body crating.

2.Remove all screws fastening the wood frame enclosure. Spread wood frame open and lift away from plastic-bagged stove body. The bottom pieces of pallet wood will remain bolted to the stove body.

3.Remove plastic bag from stove body.

4.Remove back panel from stove and discard (see Figure 6). Use an adjustable wrench or a 10 mm socket. Remove six (6) bolts and washers. Keep bolts and washers to reattach rear cover.

5.Remove all contents from inside stove cavity. Contents include:

(1)- Stove bottom (Discard - Not used with this application)

(4)- Legs with leg leveler bolts

(1)- Bottom door

(3)- Top grates

(1)- Hardware kit bag with fasteners

6.Carefully lay stove body on back to attach bottom components to stove body (see Figure 7). Rest stove on drop cloth or blanket to avoid scratching stove edges.

7.Remove remaining pallet wood attached to bottom of stove body (see Figure 8). Use an adjustable wrench to remove bolts.

8.Fasten each leg to stove with four (4) M8 x 1.25 - 20mm bolts. Use a flat washer and lock washer with each bolt. Tighten bolts into threaded holes on stove body (see Figure 9 and Figure 10 on page 6). Use an adjustable wrench or a 12mm socket.

Bolt

Back Stove

Panel

Product

Identification

Label

Figure 6 - Removing Back Panel
Top of Stove Unit		Top of
Front of	Front of	Top of
	Front of	Stove
	Stove Unit	Stove
Stove	Stove Unit	Unit
Unit
Drop	Pallet
Drop	Wood
Cloth/	Bolted to
Blanket	Bottom of
	Stove
	Body