6
CAST IRON STOVE AND
Stove Body Assembly (Cont.)
CAST IRON STOVE AND
Continued
9.Attach stove door by inserting step bolt through door hinge pivot hole and into threaded hole in stove body (see Figure 11 and Figure 9 on page 5). Use an adjustable wrench or a 12mm socket to fasten step bolt. Tighten step bolt until snug. Make sure door moves freely.
10.Install door catch bolt (M8 x
11.Check general catch bolt alignment with door claw. Make fi- nal adjustment and door leveling after stove is in normal stand- ing position.
12.Carefully lift stove back up on its four attached legs.
13.Remove 2 bolts from bottom of stove and discard. Remove bolt from the top of the stove to remove the front panel assem- bly (see Figure 13).
Washers | Bottom Of |
| |
Bolt | Stove Unit |
Leg
Figure 10 - Attaching Stove Legs
14.Lay the front panel assembly face down on a protected sur- face. Remove the two screws that hold the front plate onto the front surround plate (see Figure 14). Save these screws.
15.Remove the seven screws and washers that hold the screen onto the front surround plate. Discard these screws, washers, and screen. They are for
16.Replace the two screws from step 14 to reassemble the front plate and the front surround plate. Set this assembly aside un- til burner system has been installed, logs have been placed inside of burner system, and glass door to burner system insert has been replaced.
Bolt Stop
Adjusting Nut
Door | Door Claw |
Catch Bolt
Figure 12 - Catch Bolt and Door Claw Orientation
Bolt
Stove Body
Front
Assembly
| Figure 13 - Removing Front Assembly | |
Stove Door | Screws | |
Front Surround | ||
Threaded Hole | ||
Plate | ||
Door Hinge | Screw with | |
| Washer | |
| Screen | |
Step Bolt |
| |
Bolt Shoulder | Front Plate | |
| ||
Figure 11 - Attaching Stove Door | Figure 14 - Removing Screen from Front Assembly |
For..com