Multiquip manual MVH-702DRSC Battery Charging, Chargingthe Battery

MVH-702DRSC — BATTERY CHARGING

CHARGINGTHE BATTERY

The battery can be charged in three different ways:

Using the remote cable

Using the AC plug-in battery charger

Solar Energy

Battery Charging Using Remote Cable

1.Make sure that the engine is stopped before charging.

2.If the temperature of the hydraulic tank or its surroundings is high, wait for it to cool down before charging.

3.Open the rear cover of the machine.

4.Unpack the remote cable which can be found in a bag on the side of the machine ( Figure 10).

Location of

Remote

Control

Cable

Figure 10. Location of Remote Control Cable

5.Remove the cover of the remote control receptacle on the machine (Figure 11).

Remove cover and connect one end of remote cable (Machine)

Remove cover and connect other end of remote cable (Transmitter)

Figure 11. Remote Control Cable Connections

6.Connect one end of remote cable to the receptacle.

7.Make sure that the transmitter main switch is off.

8.Remove the cover of the remote control receptacle in the transmitter (Figure 11).

9.Connect the other end of the remote cable to the receptacle.

10.Turn the machine main switch on.

11.The charge lamp flashes while the battery is being charged.

12.The charge lamp will automatically go off after the battery is fully charged.

If the charge lamp does not light

NOTEwhen the remote cable is con- nected,thebatterydoesnotrequire charging.

Battery Charging Using AC Plug-In Charger

1.Switch off the transmitter main switch to stop battery consumption. The battery can be charged though, even with the main switch on.

2.Remove the cover of the battery charger receptacle on the transmitter. See Figure 7, item 11 for location.

3.Connect the AC plug-in charger to the receptacle.

4.The charge lamp lights while the battery is being charged.

5.The charge lamp will automatically go off after the battery is fully charged.

If the charge lamp does not light

NOTEwhenthecharger isconnected,the battery does not require charging.

Battery Charging Using Solar Energy

1.Solar Cell Charging can be done whether the transmitter main switch is on or off.

2.Expose the solar cells of the transmitter to sunlight frequently for non-operational daily charging.

Battery Charging Time

Using remote cable - approximately 2 - 3 hours

Using battery charger - approximately 2 hours

Using Solar Energy - supplemental, available anytime

MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03) — PAGE 21