Safety Information
BlaDe SaFeTY
warning
Rotating blade can cut and crush. alwaYS keep hands and feet clear while operating
the saw.
CauTion
never operate the saw without blade guards and covers in place. Exposure of the diamond blade must not exceed 180 degrees.
Verify the engine start switch is set to the OFF position before installing a blade.
alwaYS inspect blade before each use. The blade should exhibit no cracks, dings, or fl aws in the steel centered core and/or rim. Center (arbor) hole must be undamaged and true.
NOTICE
Use proper blades and follow blade manufacturer’s recommendations. Match the blade RPM (blade shaft RPM) to the recommended blade surface feet per minute (SFPM).
Ensure the 5/8"
alwaYS examine blade flanges for damage and excessive wear.
Ensure the blade is marked with an operating speed greater than the spindle speed of the saw.
Only cut the material that is specifi ed for the diamond blade. Read the specifi cation of the diamond blade to ensure the proper tool has been matched to the material being cut.
If wet cutting, ensure a weT CuTTing blade is being used and that the water supply system to the blade is properly functioning and being used.
Do noT drop the diamond blade on ground or surface.
Ensure that the blade is mounted for proper operating direction.
Adhere to the blade manufacturer’s recommendations on handling, storage and safe usage of blades.
engine SaFeTY
warning
Do noT place hands or fingers inside engine compartment when engine is
running.
never operate the engine with heat shields or guards removed.
Keep fi ngers, hands hair and clothing away 
from all moving parts to prevent injury.
alwaYS shut down the engine before performing service or maintenance.
Do noT remove the engine oil drain plug while the engine is hot. Hot oil will gush out of the oil tank and severely scald any persons in the general area of the saw.
CauTion
never touch the hot exhaust manifold, muffl er or cylinder. Allow these parts to cool
before servicing equipment.
Make certain the operator knows how to and is capable of turning the engine OFF in case of an emergency.
NOTICE
never run engine without an air fi lter or with a dirty air fi lter. Severe engine damage may occur. Service air fi lter frequently to prevent engine malfunction.
never tamper with the factory settings of the engine or engine governor. Damage to the engine or equipment can result if operating in speed ranges above the maximum allowable.
SP118 Pavement Saw • operation manual — rev. #1 (05/03/12) — page 11
