Multiquip SP118 Specific Tools to be Used, Damaged or worn blades and replace with fresh blade

INSPECTION/setup

3.Check V-belt tension by using a tension meter (3.0 lbs./1.36Kg) against the inside belt at a mid point between the two pulleys, or by deflecting the center belt at a mid point 3/16" (5 mm).

Figure 9. V-Belt Alignment

4.DO NOT over or under tighten the V-belts. Severe damage can occur to the saw and engine crankshaft if the belt is over-tensioned. A decrease of power to the blade and poor performance will result if the belt is under-tensioned (loose on pulleys).

NOTICE

V-belt alignment must be rechecked after adjusting belt tension.

SPECIFIC TOOLS TO BE USED

This saw is to use tools (blades) as follows:

„„Steel Core Segmented or Continuous Diamond Rim Cutting Wheel.

Any other type of tool is not to be used. See Table 6 for specific blade usage for material.

WARNING

Failure to thoroughly inspect the diamond blade (Figure 10) for operational safety could result in damage to the blade or the saw, and may cause injury to the user or others in the operating area. Discard

damaged or worn blades and replace with fresh blade.

SP118 Pavement Saw • operation manual — rev. #1 (05/03/12) — page 23