Multitech MT2834BAI, MT1432BA manual $SBn, SFn, $SPn, #Tn, 136

MultiModemBA User Guide

Command	Values	Description
Sr?	r = 0-11, 13,	Reads value of Register “r” and displays
	15-19, 24-26,	value in 3-digit Decimal format.
	30, 32 or 34...
$SBn	n = speed	2834 Series:
		$SB300 selects 300 bps at serial port.
		$SB1200 selects 1200 bps at serial port.
		$SB2400 selects 2400 bps at serial port.
		$SB4800 selects 4800 bps at serial port.
		$SB9600 selects 9600 bps at serial port.
		$SB19200 selects 19,200 bps at serial port.
		$SB38400 selects 38,400 bps at serial port.
		* $SB57600 selects 57600 bps at serial port.
		$SB115200 selects 115200 bps at serial port.
		1432 Series:
		$SB300 selects 300 bps at serial port.
		$SB1200 selects 1200 bps at serial port.
		$SB2400 selects 2400 bps at serial port.
		$SB4800 selects 4800 bps at serial port.
		$SB9600 selects 9600 bps at serial port.
		$SB19200 selects 19,200 bps at serial port.
		$SB38400 selects 38,400 bps at serial port.
		* $SB57600 selects 57600 bps at serial port.
		932 Series:
		$SB300 selects 300 bps at serial port.
		$SB1200 selects 1200 bps at serial port.
		$SB2400 selects 2400 bps at serial port.
		$SB4800 selects 4800 bps at serial port.
		$SB9600 selects 9600 bps at serial port.
		$SB19200 selects 19,200 bps at serial port.
		* $SB38400 selects 38400 bps at serial port.
&SFn	n = 0 or 1	* &SF0 selects DSR follows CD.
		&SF1 selects DSR independent.
&Sn	n = 0, 1 or 2	&S0 forces Data Set Ready On.
		* &S1 lets Data Set Ready act normally.
		&S2 Data Set Ready drop is regulated by S24 on
		disconnect.
$SPn	n = 0 or 1	* $SP0 disables UUCP Spoofing
		$SP1 enables UUCP Spoofing
T		Modem will tone-dial numbers following the T.
&Tn	n = 4 or 5	&T4 means Enable Response to Request for
		Remote Digital Loopback.
		* &T5 means Disable Response to Request for
		Remote Digital Loopback.
#Tn	n = 0 or 1	#T0 turns off Trellis Coded Modulation
		* #T1 turns on Trellis Coded Modulation

* Factory Default Setting

136