Multitech MT2834BAI, MT1432BA manual S26 Failed Password Attempts, S29 Local Inactivity Timer

MultiModemBA User Guide

S26

Failed Password Attempts

Unit:	1 failed attempt
Range:	0-255
Default:	0
Description:	S26 counts the number of times there has been a failed password attempt. For
	example, if you entered ATS26? the message 003 would be displayed, meaning
	someone has failed three times to gain access to your modem using its password
	security system.

S29

Local Inactivity Timer

Unit:	minutes
Range:	1-255
Default:	20
Description:	S29 defines the amount of idle time that can elapse between AT commands after the
	SETUP password has been entered. If this timer expires, the LOGIN and SETUP
	passwords will have to be re-entered. S29 only takes effect when the modem has
	been sent a #DB1 command, which secures the modem from local and remote
	configuration or dialing (i.e., no AT commands can be sent until the LOGIN and
	SETUP passwords have been entered).

S30

Inactivity Timer

Unit:	1 min.
Range:	0-255
Default:	0
Description:	S30 causes the modem to disconnect if no data is transmitted or received for a
	specified time. This timer runs during both Reliable and Normal error correction
	connections. The timer restarts any time a data character is passed through the
	serial port (either sent or received). If noise on the phone line causes an error to be
	received during Normal mode, this also restarts the timer. The default value is off (0).
	The inactivity timer is disabled by setting S30 to 0, which is the factory default
	setting.

S32

Time Elapse for Escape Sequence

Unit:	1 second
Range:	0-255
Default:	20
Description:	S32 sets the time period to validate the escape sequence. If the time interval expires
	before the escape sequence is employed (by hitting RETURN), the escape
	sequence is aborted. The default is 20 units.

82