Remote Configuration Options

Chapter 3 - Using the Front Panel

Remote Configuration Options

The following screens are used to configure remote configuration options. For more information about remote configuration, see Chapter 5, “Remote Configuration.”

ENABLE/DISABLE R.C. Use the Æ and Enter buttons to turn remoteconfiguration on or off.

REMOTE CONFIG. PASSWORD. Use to enter the remote con- figuration password. To scroll through a list of digits and charac- ters, press the ÇÅ and È buttons. To go to the next position, press the Æ button. To back up or to exit without saving, press the Æ button several times. To save the password, press the Enter button.

Diagnostic Options

Use the following screens to turn loopback tests on and off.

ANALOG LOOPBACK. Press the Æ and Enter buttons to start the analog loopback test. The TEST IN PROGRESS screen appears. To stop the test, press the Æ and Enter buttons again.

DIGITAL LOOPBACK. Press the Æ and Enter buttons to start the local digital loopback test. The TEST IN PROGRESS screen appears. To stop the test, press the Æ and Enter but- tons again. Same as the &T3 command.

REMOTE DIGITAL LOOPBACK. Press the Æ and Enter but- tons to start the remote digital loopback test. The TEST IN PROGRESS screen appears. To stop the test, press the Æ and Enter buttons again. Same as the &T6 command.

Note: Digital Loopback and Remote Digital Loopback tests must be performed using AT Commands. The LCD option to run these tests has been temporarily removed.

Phone Number Memory Options

Use the following screens to list, enter, and dial stored phone numbers. Up to four phone numbers can be stored. The number in memory location 0 is used for DTR dialing, if DTR dialing is enabled. Note: Only 16 characters can be displayed at a time. To display characters 17–30, press the È button. To go to the previous screen, press the Å button. To go to the next screen, press the Æ button.

LIST PHONE NUMBERS. Press the Æ button several times to display the phone number stored in each memory location.

ENTER PHONE NUMBERS. Use to store up to four phone num- bers in memory locations 0–3. Each number can have up to 30 characters. To scroll through a list of digits and characters, press the ÇÅ and È buttons. To go to the next position, press the Æ button. To back up or to exit without saving, press the Æ button several times. To save the number, press the Enter button. Same as the &Z= commands.

DIAL STORED NUMBERS. Press the Æ and Enter buttons to dial a stored phone number. Same as the DS= commands.

Multi-Tech Systems, Inc. MT5600BA/BL Series User Guide (S000276E)

27

 

Page 27
Image 27
Multitech MT5600BA, MT5600BL manual Remote Configuration Options, Diagnostic Options, Phone Number Memory Options