MAINTENANCE
MAINTENANCE CHART
FREQUENCY | MAINTENANCE REQUIRED | COMMENTS |
|
|
|
Daily or before each | Maintenance engine. | Refer to the Engine Owner’s Manual. |
use |
|
|
|
|
|
| Examine blade(s). | Check for cracks, wear, and excessive |
|
| damage. |
|
|
|
| Remove debris from unit and mowing area. |
|
|
|
|
| Examine all rotating and sliding parts. |
|
|
|
|
| Check tire inflation. | Refer to the Maintenance section. |
|
|
|
| Verify that the mower housing is level. | Refer to the Maintenance section. |
|
|
|
| Examine V−belts. | Check for cracks, wear, and excessive |
|
| damage. |
|
|
|
| Check brake operation. | Refer to the Operation and Maintenance |
|
| sections. |
|
|
|
After completion of | Change oil. | Refer to the Engine Owner’s Manual. |
first 5 hours |
|
|
|
|
|
After 25 hours | Maintenance engine. | Refer to the Engine Owner’s Manual. |
|
|
|
| Remove, examine, sharpen, and balance | Refer to Maintenance section. |
| blade(s). |
|
|
|
|
| Check adjustments: | Refer to Maintenance section. |
| a. Blade Rotation Control |
|
| b. Brake |
|
| c. Clutch |
|
| d. Steering |
|
|
|
|
| Lubricate chassis and mower housing. | Refer to Where to Lubricate instructions. |
|
|
|
| Check the muffler: | Refer to Maintenance section. |
| a. Torque |
|
| b. For wear or burn out |
|
| c. Condition of spark arrestor, (if applicable). |
|
|
|
|
Before storage of 30 | Prepare engine for storage. | Refer to the Engine Owner’s Manual. |
days or more |
|
|
|
|
|
| Drain fuel system. | Refer to warnings in the Owner’s Manual. |
|
|
|
| Add fuel stabilizer. | Refer to the Engine Owner’s Manual. |
|
|
|
| Prepare battery for storage: |
|
| a. Remove from unit. |
|
| b. Fully charge. |
|
| c. Move to cool dry place. |
|
|
|
|
GENERAL RECOMMENDATIONS
1.The owner’s responsibility is to maintain this product. This will extend the life of the product and is also necessary to maintain warranty coverage.
2.Check the spark plug, drive brake, lubricate the unit, and clean the air filter once a year.
3.Check the fasteners. Make sure all fasteners are tight.
4.Follow the Maintenance section to keep the unit in good operat- ing condition.
WARNING: Before you make an inspection, adjust- ment, or repair to the unit, disconnect the wire to the spark plug. Remove the wire from the spark plug to prevent the engine from starting by accident.
NOTE: Torque is measured in foot pounds (metric Nm). This measurement describes how tight a nut or bolt must be. The torque is measured with a torque wrench.
HOW TO
CHECK THE MUFFLER
Check the muffler every 50 hours. Make sure the muffler is correctly mounted and is not loose. If the muffler is worn or burnt, replace with a new muffler. A worn muffler is a fire hazard and can also damage the engine.
If you mount a spark arrester to the muffler, also check the spark arrester when you check the muffler. If the spark arrester is worn or damaged, replace it with a new spark arrester. See your nearest authorized service center for a spark arrester.
F−050611L | 23 |
