Murray 615000x30NA owner manual Assembly, Shipping Carton

ASSEMBLY

Your Snowthrower was completely assembled at the factory, except for the upper handle assembly.

Shipping Carton

Carefully remove complete unit from carton. Make sure parts bag and all components have been removed before discarding carton.

The shipping carton contains the following items:

SSnowthrower housing, with lower handles attached.

SUpper handle loosely attached to lower handle by the wire harness.

SKey, found in rear of control bar.

SPlastic bag, containing the following parts (Figure 1):

SWarranty registration Owner’s Manual Spare Key

Plastic probe

Mini wrench/drive pulley tool

(2)1/4 – 20 x 1 1/4 carriage bolts

(2)1/4 – 20 locknuts

(1)Plastic Strain Relief

Assembly

Remove and discard wire protector from lower handle tube. Figure 2.

NOTE: Care should be given as not to damage wire harness while assembling Snowthrower.

NOTE: You may find it difficult to slide the upper handle assembly into the lower handle during initial assembly. This is due to the close tolerance fit between the upper and lower tubes, required to ensure a rigid assembly. If this problem arises proceed as follows:

SPlace a small amount of grease or oil on the inside of lower tubes. This will ensure a smooth and even fit when sliding upper tubes into lower tubes.

SFold wire harness, and insert excess wire into lower right handle tube. Put as much of the wire harness as possible into lower tube.

SWhile holding lower grip firmly, carefully slide the right and left upper handle tubes into lower handle tubes until holes are aligned evenly on both sides. DO NOT DAMAGE WIRE HARNESS. Figure 3.

SWipe off any excess grease or oil.

Plastic Strain Relief

Spare Key

Plastic Probe

Carriage Bolts	Locknuts	Mini Wrench/Drive
		Pulley Tool	Figure 1

Plastic Wire

Protector

Lower Handle Tube

Figure 2

Lower Handle

Grip

Upper Handle

Tube

Lower Handle

Tube

Figure 3

F-031061C 4