Musical Fidelity A1, Class A Integrated Amplifier A1 Integrated

A1 Integrated GENERAL ADVICE

Issue 2: 05th March 2008 Page 4 of 13

This new A1 is designed and built to provide trouble-free performance, but as with all electronic devices it is necessary

to observe a few precautions:

Heed all warnings shown on the back of the product.

Only connect the A1 to a mains outlet having the same voltage as marked at the back of the unit.

Always ensure that when disconnecting and reconnecting your audio equipment the mains supply is switched

off.

Position the mains lead and signal interconnects where they are not likely to be walked on or trapped by items

placed on them.

Do not use near water, or place water-filled containers on the A1, for example, a flower vase or potted plants.

If water does spill inside, immediately pull out the mains plug from the wall socket and inform your

dealer, who should then check the unit before further use. Entry of liquid into the A1 is dangerous, and

may cause electric shock or fire hazard.

Do not place the unit near direct heat sources such as radiators, direct sunlight or other equipment.

Do not remove any covers or try to gain access to the inside. There are no internal adjustments or fuses you

can replace yourself. Refer all service work to an authorised Musical Fidelity agent.

Note: Unauthorised opening of the equipment will invalidate any warranty claim.

Dust regularly with a soft cloth or soft brush but be careful when using cleaning or polishing agents - they may

harm the surface finish.

The electronics in modern hi-fi equipment is complex and may, therefore, be adversely affected or damaged by

lightning. For protection of the audio system during electrical storms, remove the mains plugs and disconnect any

aerial lead.

If after-sales service is required, to help the dealer identify the A1 please quote the serial number located on the rear

panel of the unit.