Identification of Controls

FRONT PANEL

12INPUT SELECT : Use to select an audio/video input along with its

assigned analog or digital inputs Toggle to select through: Internal DVD CABLE/SAT VCR VIDEO 4 Internal AM tuner Internal FM tuner then back to Internal DVD. (See also section about “Input Select” under “Setting up the L 54”).

13VOLUME (SETUP) : Turn clockwise to increase the volume setting; counter clockwise to lower it. The VFD shows the setting displayed as increments between -61 through to 17.

The VOLUME knob is also used to increment/decrement Bass/Treble level, LEFT/RIGHT balance, set DRC level and turn ON/OFF SRS.

14SCAN/TUNE : Pressing momentarily the or button will

manually scan the AM or FM band. Press and hold or for more than 2 seconds to search up or down; the L 54’s tuner will stop at the next sufficiently strong signal it encounters. Note too that this function “wraps,” and will continue searching up or down from one end of the AM or FM band to the other.

Press or during disc playback. Press repeatedly to select the desired scanning speed.

15SKIP/PRESEt :At AM/FM mode, press to step up or down between stored radio presets; 30 FM and 30 AM station presets are available. Note

that this function “wraps”: Pressing or will step from Preset 30 to Preset 1, or vice versa. “Unused” presets are skipped over.

In DVD mode, press to skip forward or to skip backward a track

or chapter. When setting up the Timer, use the or buttons to change the hours and minutes.

16VFD : The Vacuum Fluorescent Display (VFD) provides visual information on all of the L 54’s important modes, settings and functions.

17VIDEO 4 INPUT : Use these convenience jacks for occasional sources such as a camcorder, tape player, video game console or any other analog audio and composite/S-Video video sources. Select the Video 4 input using the HTR 4 remote or through the front panel“INPUT SELECT” button.

If your source has a single audio out jack only or is marked ‘mono output’ , plug this into the L 54’s Video 4 ‘R (Mono)’ input. On the other hand, if your source has two output jacks indicative of stereo output, insert both jacks into the L 54’s corresponding Video 4 ‘L’ and ‘R (Mono)’ input to achieve stereo output as well.

18PHONES : Accepts stereo headphone using a standard 1/4-inch stereo phone plug (use a suitable adaptor for headphones equipped with a smaller plug). Plugging in headphones automatically mutes output from the speakers (but not from the AUDIO OUT jacks of the VCR at SRS OFF).

ENGLISH

FRANÇAIS

ESPAÑOL NEDERLANDS DEUTSCH

ITALIANO

РУССКИЙ

SVENSKA

Page 9
Image 9
NAD L 54 owner manual SCAN/TUNE Pressing momentarily the or button will