NAD M55 owner manual Connecting to a TV Directly, Nederlands Deutsch Français English

Introduction

CONNECTING TO A TV DIRECTLY

S-VIDEO of the M55 to the

S-Video of the TV

Composite VIDEO OUT Jack of the M55 to the composite video of the TV

COMPONENT VIDEO OUT Jacks of the M55 to the component video of the TV

SCART/RGB OUT Jack of the M55 (EURO version) to the 21- pin SCART of the TV

NEDERLANDS DEUTSCH FRANÇAIS ENGLISH

TV or monitor with audio/video inputs

NOTE

75-Ohm video and audio cables are supplied with the M55. SCART and S-Video cables can be purchased from your local NAD retailer.

WARNING

Do not connect the Digital Audio Output of this DVD player unless you are connecting the DIGITAL OUT jack of this DVD player to a TV that is equipped with an AV decoder that has the Dolby Digital decoding function. High volume sound may damage your hearing as well as the speakers. (Refer to Initial Setup Settings, Audio)F

NOTES

•Refer to the owner’s manual of your receiver as well.

•Before you connect the M55 to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before making any connections.

•Depending on your Digital sound decoder, the decode rate may be 96 kHz or 48 kHz.

•The output sound of the M55 has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.

•Turn off the receiver before you connect or disconnect the M55’s power cord. If you leave the receiver power on, the speakers may be damaged.

SVENSKA PORTUGUÊS ITALIANO ESPAÑOL

25