NAD M55 owner manual Rear Panel European Version

ENGLISH FRANÇAIS DEUTSCH NEDERLANDS ESPAÑOL ITALIANO PORTUGUÊS SVENSKA

Identification of Controls

REAR PANEL (EUROPEAN VERSION)

1	IR IN Jack	10	HDMI OUT Jack (480p/576p, video resolutions)
2	DIGITAL OUT COAXIAL Jack	11	VGA OUT Jack (480p/576p, 720p, and 1080i video resolutions)
3	DIGITAL OUT OPTICAL jack	12	AUTO TRIGGER ON/OFF Switch
4	MIXED AUDIO OUT (L & R) Jacks	13	+12V TRIGGER IN jack
5	5.1 CH AUDIO OUT FRONT L & R Jacks	14	SCART/RGB OUT Jack (480i and 576i, video resolutions)
6	5.1 CH AUDIO OUT CENTER and SUBW (Subwoofer) Jacks	15	Power cord socket
7	5.1 CH AUDIO OUT SURR (Surround Sound) L & R Jacks	16	POWER ON/OFF
8	S-VIDEO& Composite VIDEO OUT Jacks (480i/576i video	17	RS 232 In/Out Jack
	resolutions)

9COMPONENT VIDEO OUT Jacks (480i/576i and 480p/576p, video resolutions)

NOTES

Connect the optical digital cable (not supplied) firmly so that the configurations of both the cable and the connector match.

The +12V TRIGGER IN jack is a 3.5mm monotype miniature phone jack with the centre pin the 12V signal-sense. We recommend that you use a good quality cable with shield when attaching the 3.5mm monotype plug so as to prevent false triggering of the amplifier due to electro- magnetic interference from nearby electronic equipment. The +12V-IN TRIGGER allows you to have an external 12V signal to turn ON the NAD M55 from standby. This 12V signal must be a continuous 12V signal in order to keep the M55 in the ON state. Once you remove the 12V signal the M55 will return to standby. Check the specifications of the trigger input terminal the other components to ensure these are compatible with the M55. All 12V-TRIGGER inputs and outputs on other NAD components with a 12V-TRIGGER feature are fully compatible with the NAD M55’s 12V-TRIGGER IN. Before making any connections to any 12V-TRIGGER IN make sure all components are disconnected from the AC mains. If in doubt over the connections, installation and/or operation of the 12V-TRIGGER IN connection, consult your NAD dealer or sales representative. Failure to observe the above may result in damage to the NAD M55 and/or any ancillary components attached to it.

The IR IN jack is connected to the output of an IR (infrared) repeater (Xantech or similar), or the IR output of another component to allow control of the M55 from a remote location. Ask your dealer or custom installer for further details

8