NAD M55 owner manual Preparing The Remote Control, Identification of Controls, Notes On Batteries

Models: M55

1 38
Download 38 pages 53.72 Kb
Page 9
Image 9
PREPARING THE REMOTE CONTROL

Identification of Controls

PREPARING THE REMOTE CONTROL

Insert the batteries into the remote control so you can use it to operate the M55. 1 Open the battery cover

2Insert two batteries (AA size)

3Make sure to match the + and - on the batteries to the marks inside the battery compartment.

4Close the cover

NOTES ON BATTERIES

Improper use of batteries may cause battery leakage and corrosion.

To operate the remote control correctly, follow the instructions.

Do not insert the batteries into the remote control in the wrong direction.

• Do not charge, heat, open or short-circuit the batteries.

Do not throw the batteries into fire.

Do not leave dead or exhausted batteries in the remote control.

Do not use different types of batteries together, or mix old and new batteries.

If you do not use the remote control for a long period of time, remove the batteries to avoid possible damage from battery corrosion.

• If the remote control does not function correctly or if the operating range becomes reduced, replace all batteries with new ones.

• If battery leakage occurs, wipe the battery liquid from the battery compartment, then insert new batteries.

• The batteries should last about one year with normal use.

OPERATION OF THE M55 WITH THE REMOTE CONTROL

This section shows you how to use the remote control. Point the remote control at the remote control sensor and press the buttons.

30° 30° 23 ft (7m)

Distance: About 23 ft (7 m) from the front of the remote sensor

Angle: About 30 degrees in each direction of the front of the remote sensor

NOTES ON THE REMOTE CONTROL

Do not expose the remote sensor of the M55 to a strong light source such as direct sunlight or illumination. If you do so, you may not be able to operate the M55 with the remote control.

Point the remote control at the remote sensor on the M55.

Do not drop or give the remote control a shock.

Do not leave the remote control near an extremely hot or humid place.

Do not spill water or put anything wet on the remote control.

Do not disassemble the remote control.

SVENSKA PORTUGUÊS ITALIANO ESPAÑOL NEDERLANDS DEUTSCH FRANÇAIS ENGLISH

9

Page 9
Image 9
NAD M55 Preparing The Remote Control, Identification of Controls, Notes On Batteries, Notes On The Remote Control