2
TABLE of CONTENTS
Pg
Warranty
General Instructions
General Information
Care of Glass & Plated Parts
Dimensions
Vent Lengths
Minimum Air Terminal Location Clearances
Venting Application Flow Chart
Typical Minimum and Maximum Vent Lengths
Special Vent Installation
Venting Options
Framing
Bar / Counter top Installation
Brick Panel Installation
Facing
16OPEN END INSTALLATION PROCEDURE
Framing
Brick Panel Installation Facing
17
Framing
Brick Panel Installation Facing
18VENT FRAMING DIMENSIONS
Wall and Ceiling Protection
Horizontal Venting Installation
Adjustable Firestop
Vertical Venting Installation
Flexible Vent Components
Fireplace Vent Connection
Rigid Vent Components
Gas Supply Connection
Mantel Installation and Enclosures
Heat shield
Log Placement
Logo Placement
Door Installation
Louvre Installation
End Door Installation
26OPTIONAL BLOWER INSTALLATION
27OPERATION / MAINTENANCE
Operating Instructions Maintenance
28ADJUSTMENTS
Pilot Burner Adjustment
Venturi Adjustments
Restricting Vertical Vents
Ordering Replacement Parts
Replacement Parts
Vent Kits
Terminal Kits
31 ACCESSORIES
34SERVICE HISTORY
!WARNING
•Do not burn wood or other materials in this fireplace.
•Adults and especially children should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition. Supervise young children when they are in the same room as the fireplace.
•Clothing or other flammable material should not be placed on or near the fireplace.
•Due to high temperatures, the fireplace should be located out of traffic and away from furniture and draperies.
•Ensure you have incorporated adequate safety measure to protect infants/toddlers from touching hot surfaces.
•Even after the fireplace is out, the glass and/or screen will remain hot for an extended period of time.
•Check with your local hearth specialty dealer for safety screens and hearth guards to protect children from hot surfaces. These screens and guards must be fastened to the floor.
•Any safety screen or guard removed for servicing must be replaced prior to operating the fireplace.
•It is imperative that the control compartments, burners and circulating blower and its passageway in the fireplace and venting system are kept clean. The fireplace and its venting system should be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. The fireplace area must be kept clear and free from combustible materials, gasoline and other flammable vapours and liquids.
•Under no circumstances should this fireplace be modified.
•This fireplace must not be connected to a chimney flue pipe serving a separate solid fuel burning appliance.
•Do not use this fireplace if any part has been under water. Immediately call a qualified service technician to inspect the fireplace and to replace any part of the control system and any gas control which has been under water.
•Do not operate the fireplace with the glass door removed, cracked or broken. Replacement of the glass should be done by a licensed or qualified service person.
•Do not strike or slam shut the fireplace glass door.
•This fireplace uses and requires a fast acting thermocouple. Replace only with a fast acting thermocouple supplied by Wolf Steel Ltd.
•Pressure relief doors must be kept closed while the fireplace is operating to prevent exhaust fumes containing carbon monox- ide, from entering into the home. Temperatures of the exhaust escaping through these openings can also cause the surrounding combustible materials to overheat and catch fire.
•Only doors / optional fronts certified with the unit are to be installed on the appliance.
NOTE: CHANGES, OTHER THAN EDITORIAL, ARE DENOTED BY A VERTICAL LINE IN THE MARGIN.
