16
FIGURE 33
DOOR OPENING
(To open the door, the trim must be removed.) When opening the fire viewing door, a simple procedure must be followed in order to not damage the door. First open the valve control door. Next remove the louvres located above the door. The door is se- cured by two latches at the top and an- other two at the bottom. Pull the latch han-
dles towards you and release each catch. The door may now be safely opened.
L45 LOUVRE INSTALLATION
FIGURE 34a-c
A |
B
C
To close the door, repeat in reverse order.
DOOR REMOVAL
To remove the door, fully open to 90°, lift up and off.
TRIM INSTALLATION
The 2 vertical trim pieces are each held on with two mag- nets. Attach the trim to the magnets.
GDL45 LOUVRE INSTALLATION
The louvre assemblies are installed as illustrated in figure
33.In addition, the louvre hood, located above the upper louvres, is held in place with 4 clips. Slide the short leg of the louvre hood into the clips, as shown.
A | CLIPS |
| FLANGE |
| SLOT |
| SLOT |
| TA B |
B |
|
C |
|
HINGE | SLOT |
| |
CLIP |
|
HOOD
Attach the hood by pressing the top flange into the clips along the top of the louvre opening. Secure using two screws located through the slots.
UPPER LOUVRES
Insert the louvre tabs into the slots located at the top left and right corners of the unit.
LOWER LOUVRES
Insert the hinge clips into the slots located at the bottom left and right corners of the unit.
To remove the louvres, pull the back tabs of the clips forward, while pushing the louvre assembly back. Lift the clip.