LIGHTING INSTRUCTIONS

Open lid.

Ensuring all burner controls are in the off position,

slowly turn on the gas supply valve.

SIDE

BURNER

LEFT

BURNER

CENTRE

BURNER

REAR

RIGHT

 

BURNER

 

BURNER

REAR BURNER IGNITER

 

Main Burner Lighting

Push in on any main burner knob and turn to “HI”. A

click should be heard from the valve, sending a spark

to light the pilot flame.

If ignition is not immediate,

turn burner control off.

Wait 5 minutes.

If the burner will not light after several attempts, it can be lit by inserting a lit extended match or lighter through the cooking grids

to the burner. Push the knob in and turn to “HI”.

Rear Burner Lighting

Remove warming rack. (the excess heat will cause the rack to warp.)

Push the knob and hold

for approximately 5

seconds before rotating. This allows gas to reach the rear burner. Rotate the knob to “HI” and press

the igniter button.

If ignition is not immediate,

turn burner control off.

Wait 5 minutes.

If the burner will not light after several attempts, it can be lit by holding a lit extended match or lighter against the burner. Push the knob in and turn to “HI”.

Side Burner Lighting

Open burner cover.

Push the side burner

control knob and turn to “HI” position. A click should be heard form the valve, sending a spark to light the pilot flame.

If ignition is not immediate,

turn burner control off.

Wait 5 minutes.

If the burner will not light after several attempts, it can be lit by holding a lit extended match or lighter against the burner. Push the knob in and turn to “HI”.

The propane cylinder is equipped with an excess flow device. Unless all burners are turned off prior to turning the cylinder on, only small flames and low heat will be achievable.

6

Page 6
Image 6
Napoleon Grills CSS610RSB manual Lighting Instructions, Open lid