Appendix A Default Settings
©
National Instruments Corporation A-3 VXI/VMEpc 600 Series for Windows 95/NT
VXI/VME-MXI-2
This section summarizes the software default settings for the VXI-MXI-2
and VME-MXI-2. This information is useful if you have either of these
modules in your system.
Upper half window byte
swapping Disabled
Map upper and lower halves at
same PCI address Disabled
Table A-4. VXIpc T&M Explorer PCI Tab Default Settings
Editor Field Default Setting
Low-level register access API
support Enabled
User window size 64 KB
Table A-5. VXI/VME-MXI-2 T&M Explorer Device Tab Default Settings
Editor Field Default Setting
Logical address Use DIP switch
Address space A24 *
Requested memory 16 KB *
A24/A32 write posting Disabled
A16 write posting Disabled
Interlocked mode Disabled
* Assumes no DRAM is installed. If DRAM is installed, the Address space should be
A32, and Requested memory should match the amount of DRAM. If you install the
DRAM yourself, you must manually specify these changes.
Table A-3. VXIpc T&M Explorer Shared Memory Tab Default Settings (Cont inued)
Editor Field Default Setting