© National Instruments Corporation A-1 FBUS-HSE/H1 LD User Manual
A

Resetting the FBUS-HSE/H1 LD

If the FBUS-HSE/H1 LD cannot communicate with the network, you can
configure the Ethernet settings through NI-FBUS software. When you
configure the device, it attempts to confirm that the new settings are
valid.However, if the configuration process is interrupted or the
FBUS-HSE/H1 LD is moved to a new network with different settings,
the device might not be able to communicate with the network. If this
occurs, you can manually reset the unit to its factory settings.
Complete the follow steps to reset the unit.
1. Power down the FBUS-HSE/H1 LD and remove it from the bank.
2. Locate the slot on the bottom of the FBUS-HSE/H1 LD just above the
label. Inside the slot, find the red reset switch, shown in FigureA-1.