Chapter 2 Hardware Installation and Configuration
FBUS-HSE/H1 LD User Manual 2-2 ni.com
Figure 2-2. Mounting the FBUS-HSE/H1 LD on a DIN Rail
3. Slide the FBUS-HSE/H1 LD to the desired position along the DIN rail.
After the FBUS-HSE/H1 LD is in position, lock it to the DIN rail by
pushing the rail clip to the locked position, as shown in Figure 2-1.
Removing the FBUS-HSE/H1 LD
To remove a linking device, unlock it from the DIN rail by placing a
screwdriver in the slot on the rail snap and open the rail snap to the
unlocked position, as shown in Figure 2-1. Then lift the device off of the
rail.
1Cover
2Lip
3 35 mm DIN Rail
4 Press on to Rail
4
1
2
3