Appendix A Resetting the FBUS-HSE/H1 LD
FBUS-HSE/H1 LD User Manual A-2 ni.com
Figure A-1. FBUS-HSE/H1 LD Reset Switch
3. Looking at the FBUS-HSE/H1 LD so that the label is upright, as shown
in Figure A-1, use a pen or a small screwdriver to move the Reset
switch to the right.
4. Power up the FBUS-HSE/H1 LD and wait for the red STATUS LED
to flash. When the LED flashes, the FBUS-HSE/H1 LD is in Reset
mode.
5. Power down the FBUS-HSE/H1 LD and move the Reset switch back
to the left.
6. Reattach the FBUS-HSE/H1 LD to the rail or panel.
7. Power up the FBUS-HSE/H1 LD.
Note There are three switches on the FBUS-HSE/H1 LD. The Reset switch is at the right
in Figure A-1. The other two switches are reserved for future use. You should not change
the Reset Switch unless you want to reset the device.
Made in the USA
Reset Switch
Normal Reset