Chapter 2 Hardware Installation and Configuration
FBUS-HSE/H1 LD User Manual 2-4 ni.com
Connect Your FBUS-HSE/H1 LD to the Network
Connect the RJ-45 Ethernet port of the FBUS-HSE/H1 LD to an Ethernet
hub using a standard Category 5 Ethernet cable. You also can connect an
FBUS-HSE/H1 LD directly to a computer using an Ethernet crossover
cable.
Note Do not use a cable longer than 100m. If you are using a 10 Mbps Ethernet, National
Instruments recommends using a Category 5 shielded twisted-pair Ethernet cable.
Figure2 -4 shows the power, H1, and Ethernet connectors on the
FBUS-HSE/H1 LD.
Figure 2-4. Connectors on the FBUS-HSE/H1 LD
1H1 Port 1 2H1 Port 2 3 Power 4 Ethernet
1 2 3
4