
©NationalInstruments Corporation 2-1 RTSeries DAQ DeviceUser Manual
2
Installation and ConfigurationThis chapter explains how to install and configure your RT Series DAQ
hardware.
Installing the Hardware
Youcan install the RT Series DAQ device in any available expansion slot
inyour computer or PXI chassis. To reduce noise, however, leave as much
roomas possible between the RT Series DAQ device andother devices and
hardware.The following are general installation instructions. Refer to your
computeruser manual or technical reference m anual forspecific
instructions and warnings about installing hardware.
Note Install LabVIEW Real-Time(RT) and NI-DAQ before you install your RTSeries
DAQdevice. Refer to Chapter 2, Installation,oftheLabVIEWReal-TimeUser Manual for
information about installing LabVIEW RTand NI-DAQ.
PCI Installation
Completethe following steps to install your RT Series PCI device.
1. Turnoff and unplug your computer.
2. Removethe cover to your computer.
3. Makesure there are n o lighted LEDs on your motherboard. If any are
lit, wait until theygo out before continuing your installation.
4. Removethe expansion slot cover on the back panel of the computer.
5. Insert the RTSeries DAQ board into a 5 V PCI slot. Gently rock the
board to easei t into place.It might be a tight fit, but do not force the
board into place.
6. Screwthe mounting bracket of the RT Series DAQ board to the back
panel rail of the computer.
7. Visuallyverify the installation. Make sure the board is not touching
other boards or components and is fully inserted in the slot.
8. Replace the cover.
9. Plug in and turn on your computer.