Navigon MN7 user manual Working with the map, Maps, Selecting a map

User’s manual MN7 PDA

Saved Routes: Opens a dialog window into which you can load a saved route.

Settings: Opens the SETTINGS window. Here you can configure the navigation system. (Refer to "Configuring the MN7 PDA" on page 50)

Show on Map: Shows the selected address on the map.

Simulation: Simulates a navigation on the route indicated. This simulation can be performed without GPS reception. On multi-leg routes, only the first leg is simulated.

Traffic: Opens the TRAFFIC INFORMATION window in which pending reports are listed. (Refer to "TMC (Traffic Information)" on page 47)

Turn-by-Turn List: Shows detailed directions for the route, including all points at which you must turn. (Refer to "Turn-by-Turn List" on page 46)

4.6Working with the map

4.6.1Maps

Each country has its own navigation map. However, seamless navigation over several maps on one continent is possible if a continuous route can be planned on the maps saved.

Even if maps from several continents are saved on the memory card in your navigation device, the MN7 PDA can only ever work with maps from one continent.

Tap on Options > Settings > Map in order to see which maps are currently in use. Here you can also select a different continent if the memory card in the navigation device contains any maps of countries on other continents.

4.6.2Selecting a map

Additional maps can be found on the product DVD. If you want to use one of these maps, copy it to the memory card in your PDA.

Note: If a DVD was not supplied with your software, you can download the software and / or navigation maps from our website www.navigon.com/MN7.

Note: During the test period you can use any of the maps without restriction. Once you have activated the software you can use only the map that you have purchased (including all smaller maps that are covered by it, i.e. if you have acquired the 'Europe' map, you will also be able to use the 'D-A-CH' map).

Proceed as follows:

- 36 - Navigation