9
Flush mounting
Locate the area where the GEONAV is to be installed, then use the cutting template supplied with the plotter to cut the panel.
Apply a layer of silicone glue (the use of black colored glue is recommended, in order to prevent the area from going yellow when exposed to sunlight) to the plastic frame rear part; place the frame into the socket cut out of the panel, so that the frame edge leans against the panel.
Make sure that the frame and the panel are correctly fixed; if necessary, apply additional metal brackets (not supplied in the package) as shown in the relevant figure.
Let the silicone glue dry, then apply the neoprene gasket to the plotter rear side, insert the instrument into the frame and lock it by the screws supplied.
Do not exceed tightening the screws, in order to avoid damag- ing the screw seats.
English
