NEC A Series user manual Quick Start, Captive Signal Cable

Quick Start

To attach the MultiSync® A Series monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.If necessary, install the display card into your system. For more information, refer to the display card manual.

3.For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws.

For the Mac: Connect the MultiSync A500™ or MultiSync A700™ Macintosh cable adapter (not included) to the monitor connector on the Macintosh (Figure B.1). Attach the 15-pin mini D-SUB end of the captive signal cable to the MultiSync A500™ or MultiSync A700™ Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.

NOTE: To obtain the MultiSync A500 or A700 Macintosh cable adapter, call NEC Technologies at (800) 820-1230.

4.Connect one end of the power cord to the MultiSync A Series monitor and the other end to the power outlet (Figure C.1).

5.Turn on the monitor (Figure D.1) and the computer.

NOTE: If you have any problems, please refer to the Troubleshooting section of this User’s Manual.

Captive Signal Cable

15-pin mini D-SUB

Figure A.1

2

78131921 4 5/21/98, 2:25 PM