Global Setup
If you change one of the global settings, you change that setting for all registered handsets. Only one handset can change global settings at a time.
Setting Day and Time
Day & Time sets the day and time of your display.
1Press the MENU soft key. Select the Global Setup menu, and then the Day & Time submenu option.
2 Press 
/vol/∧ or 
/vol/∨ to select the day of the week, and then the → soft key.
3Press 
/vol/∧ or 
/vol/∨ to set hour, and then press the → soft key.
4Press 
/vol/∧ or 
/vol/∨ to set minute, and then press the → soft key.
5Press 
/vol/∧ or 
/vol/∨ to choose A M or PM , and then press the SAVE soft key.
Day & Time idle timeout is two minutes.
Setting the Dial Mode
&C[6KOG /10 #/
=?
$#%- 5#8'
Sets the dial mode to tone or pulse. Most phone systems use tone dialing; the default setting is tone dialing. Set the dialing mode to match the dialing system used by your local phone service.
•If you are not sure of your dialing system, set the unit to tone dialing. Make a trial call. If the call connects, leave the setting as is; otherwise set the unit to pulse dialing.
•If your phone system requires pulse dialing and you need to send DTMF tones in certain situations during a call, you can switch over to tone dialing (refer to “Tone Dialing
1Press the MENU soft key. Select the Global Setup menu, and then the Dial Mode submenu.
2 Press 
/vol/∧ or 
/vol/∨ to select T o ne or P ul se (the initial setting is Tone). 3 Press the OK soft key. You will hear a confirmation tone.
Setting Voice Mail Tone
&KCN/QFG 6QPG
2WNUG
$#%- &'.'6' 1-
Voice Mail Tone sets the voice mail tone. If your service does not support SDT message signal, set your VMWI (Visual Message Waiting Indicator) not to detect SDT message signal.
1 | Press MENU soft key. Select the Global Setup menu, and then the Voice Mail Tone Submenu. |
| ||
2 | Press /vol/∧ or /vol/∨ to set the voice message indication (SDT message | 8QKEG/CKN6QPG | ||
| signal) to On or Off. | |||
| 1P |
| ||
3 | Press the OK soft key. You will hear a confirmation tone. | 1HH |
| |
$#%- | &'.'6' | 1- | ||
Deregister the Handset
Deregister HS clears the handset’s ID from the main base unit or the base ID from the handset. You will usually only deregister the handset if you are having a problem with your phone or if you need to change the digital security code. (see page 25).
1In standby mode, select Deregister HS in the menu and press the OK soft key. Deregister HS? appears.
2Press 
/vol/∧ or 
/vol/∨ to select Y es and then the OK soft key.
When deregistration is complete you will hear a confirmation tone, and
Deregistration Complete appears.
>GIKUVGT*5! ;GU
0Q
$#%- &'.'6' 1-
3After deregistering the handset, place the handset to the base to register. You must reregister the handset before you can use it.
G e t t i n g S t a r t e d | [ 1 3 ] |
