NEC DTR-IR-2 Using the Caller ID Message List, Calling a Party from the Caller ID List, Talk Mode

Using the Caller ID Message List

Calling a Party from the Caller ID List

Standby Mode

1When the phone is in standby mode, select the Caller ID message (see "Viewing the Caller ID List" on page 23).

2To have the phone dial a "1" before the displayed Caller ID number, press

*/tone/<. To have the phone dial the stored area code before the displayed Caller ID number, press #/>.

3Press talk/flash or speaker. The displayed phone number dials automatically.

Talk Mode

2/

,CPG5OKVJ



$#%- &'.'6' 5614'

1When the phone is in talk mode, select the Caller ID message you want to dial (see "Viewing the Caller ID List" on page 23).

2Press the DIAL soft key, and the number will be dialed.

Storing Caller ID Messages in the Phonebook

Messages shown in the Caller ID list can be stored in the phonebook. The phone number and name of the party on the Caller ID list can be stored in memory.

1When the phone is in standby mode, select the Caller ID message to be stored.

Then press the STORE soft key. Store/Edit Name appears. If the Caller ID message is already stored in memory, you will hear a beep and This data is already stored!! appears. The number will not be stored.

2To complete the setting, follow the steps 3-8 in "Phonebook (Storing Phone Numbers, Names, Distinctive Rings, and Speed dial)" on page 19.

• When a long distance call has been set, "1" appears in the display.

note • If the Caller ID message was received as a private/unknown number, or the message does not have the number, you cannot store the message in the Phonebook. If it was received as private/unknown name, the message will be stored as <No Name>.

•Even if the 100 memory locations are full, the message will be stored in the Phonebook. However, the message will be erased from the Caller ID list.

[ 2 4 ] G e t t i n g S t a r t e d