Additional Information

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and the base unit. Normally, setting the code is not necessary. In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code. To change the digital security code:

1De-register the handset (see “Deregister the handset“ on page 13).

2Register the handset by following step 2-3 in “Registering the handset“ on page 9.

Find Handset

To locate the handset, press find handset on the base when the phone is in standby mode. All registered handsets beep for 60 seconds, and Pa gi n g appears on the handset display. To cancel paging, press any key on the handset or find handset on the base..

If the battery pack is completely drained, the handset will not beep when paging.

note

Installing the Beltclip

To Attach the Beltclip

Insert the beltclip into the holes on each side of the handset. Press down until it clicks

To Remove the Beltclip

Pull either side of the beltclip to release the tabs from the holes.

Headset Installation

Your phone can be used with an optional headset. To use this feature, insert the headset plug into the headset jack. Your phone is ready for hands-free conversations. (Headset can be purchased by calling your local NEC Representative.)

ADDITIONAL INFORMATION

B a s i c s

[ 2 5 ]

Page 29
Image 29
NEC DTR-IR-2 user manual Additional Information, Changing the Digital Security Code, Find Handset, Installing the Beltclip