NEC ISDN-PRI manual Program 82 Basic Hardware Setup for Extension, Incoming Ring Tone

Program 82 : Basic Hardware Setup for Extension

82-01 : Incoming Ring Tone

Program 82 : Basic Hardware Setup for Extension

82-01 : Incoming Ring Tone

Level:

MF

Aspire S	Aspire
• Available.	• Available.

Description

Use Program 82-01 : Incoming Ring Tone to set the incoming ring tones, which are the tones a user hears when a call rings an extension. These tones are grouped into four ring tone Ranges (1-4), also called patterns, that consist of a combination of frequencies. (You assign a specific Range to trunks in Program 22-03 and to extensions in Program 15-02.) Within each Range there are three frequency Types: High, Middle and Low. (Service Code 820 allows users to choose the Type for their incoming calls.) Each Type in turn consists of two frequencies and the modulation “played” simultaneously to make up the tone. These frequencies are determined by their Frequency Number selected in Items 1 and 2 (see below). In this program, you assign the two Frequency Numbers and Modulation for each Type, for each of the four Ranges. The chart below shows the default Fre- quency Numbers for each Type in each Range.

Input Data

Incoming Ringing Tone Number

1 = Pattern 1 (Trunk Incoming)

2 = Pattern 2 (Trunk Incoming)

3 = Pattern 3 (Trunk Incoming)

4 = Pattern 4 (Trunk Incoming)

5 = Intercom Incoming Pattern

Ringing Tone Type Number

1 = High

2 = Mid

3 = Low

Item		Item		Input Data
No.
01	Frequency 1		1 = 520Hz
			2	= 540Hz
02	Frequency 2
			3 = 660Hz
			4	= 760Hz
			5	= 1100Hz
			6	= 1400Hz
			7	= 2000Hz
03	Modulation		0 = No modulation
			1	= 8Hz modulation
			2	= 16Hz modulation
			3	= envelope

Aspire ISDN PRI Manual ◆ 123