NEC LCD1935NXM, LCD1735NXM manual Quick Start, Turn off the power to your computer

Quick Start

To attach the MultiSync¨ LCD monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.For the PC or MAC with DVI digital output: Connect the DVI signal cable (not included) to the connector of the display card in your system (Figure A). Tighten all screws.

For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your system. Tighten all screws.

For the MAC: Connect the MultiSync Macintosh cable adapter to the computer, then attach the 15-pin mini D-SUB signal cable to the MultiSync Macintosh cable adapter. Tighten all screws.

NOTE: To obtain the MultiSync Macintosh cable adapter or DVI-D cable, call NEC- Mitsubishi Electronics Display of America, Inc. at (800) 632-4662.

4.Connect the 15-pin mini D-SUB of the video signal cable or DVI signal cable (not included) to the appropriate connector on the back of the monitor (Figure A).

5.Connect the audio cable to ÒAUDIO INPUTÓ on the back of the monitor and the other end to the ÒAudio outÓ terminal of the computer (Figure B).

6.Plug the captive power cord into the AC adapter and power cord into a wall socket (Figure C).

NOTE: If you use this monitor at AC125-240V, please refer to Recommended Use section of this manual for proper selection of power cord.

NOTE: For download information on the Windows¨ 95/98/Me/2000/XP INF file for your monitor, refer to the References section of this UserÕs Manual.

NOTE: If you have any problems, please refer to the Troubleshooting section of this UserÕs Manual.

Figure A Figure B Figure C

Outlet

AC Adapter

DVI VGA Audio Jack Power Jack

4

LCD35Seriesmanual071904.p65 4 7/19/04, 7:24 AM