Setup Procedure
English
1. Determine the installation location
CAUTION: DO NOT ATTEMPT TO INSTALL THE LCD MONITOR BY YOURSELF.
Installing your LCD display must be done by a qualified technician. Contact your dealer for more information.
CAUTION: MOVING OR INSTALLING THE LCD MONITOR MUST BE DONE BY TWO OR MORE PEOPLE. It is recommended that 4 people move or install the LCD Monitor, due to its weight of almost 63.0kg.
Failure to follow this caution may result in injury if the LCD monitor falls.
CAUTION: Do not mount or operate the display upside down, face up, or face down.
Do NOT use this monitor in the portrait position. Doing so may cause failure and void the Warranty.
CAUTION: This LCD has a temperature sensor and cooling fan. If the LCD becomes too hot, the cooling fan will turn on automatically. If the LCD becomes overheated and the cooling fan is running, the ÒCautionÓ menu will appear. If the ÒCautionÓ menu appears, discontinue use and allow the unit to cool. When the LCD monitor is used in an enclosure or with protection on LCD surface, please check the inside temperature of monitor by ÒHEAT STATUSÓ (See page 28). The temperature is too hot than normal condition, please set Òcooling fanÓ to ON on SCREEN SAVER function (See page 24).
IMPORTANT: Lay the protective sheet, which was wrapped around the LCD monitor when it was packaged, beneath the LCD monitor so as not to scratch the panel.
2. Install the remote control batteries
The remote control is powered by 1.5V AA batteries. To install or replace batteries:
1.Press and slide to open the cover.
2.Align the batteries according to the (+) and (Ð) indications inside the case.
¥Remove dead batteries immediately to prevent battery liquid from leaking into the battery compartment.
DonÕt touch exposed battery acid, it cause damage to your skin.
NOTE: If you do not intend to use the Remote Control for a long period, remove the batteries.
3. Connect external equipment (See pages
¥To protect the connected equipment, turn off the main power before making connections.
¥Refer to your equipment user manual.
4. Connect the supplied power cord
¥The power outlet socket should be installed as near to the equipment as possible, and should be easily accessible.
¥Fully insert the prongs into the power outlet socket. Loose connection may cause noise.
¥Please fix the power cord by attaching the screw and clamper.
NOTE: Please refer to ÒSafety Precautions, Maintenance & Recommended UseÓ section of this manual for proper selection of AC power cord.
Screw
Clamper
Screw hole for clamper 
3. Replace the cover.
CAUTION: Incorrect use of batteries can result in leaks or bursting.
Be careful especially about the following points.
¥Place ÒAAÓ size batteries matching the + and - signs on each battery to the + and - signs of the battery compartment.
¥DonÕt mix battery types.
¥DonÕt combine new batteries with used ones.
It causes shorter battery life or leakage of batteries.
5.Switch on the power of all attached external equipment
When connected with a computer, switch on the power of the computer first.
6.Operate the attached external equipment
Display the signal on the external equipment you wish.
7. Adjust the sound
Make adjustments when adjustment of the volume is required.
8. Adjust the screen (See pages 20-28)
Make adjustments when adjustment of the screen display position or distortion is required.
Downloaded From
