How to Mount and Attach Options to the LCD Monitor
You can attach mounting accessories to the LCD monitor in | 3. Ventilation Requirements for enclosure | ||||
one of the following two ways: | mounting | ||||
| |||||
1. In the upright position | To allow heat to disperse, leave space between surrounding | ||||
objects as shown in the diagram below. | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
English
2. Lay the screen face down
Protective Sheet
Table | Tabletop Stand |
|
Lay the protective sheet on a table, which was wrapped around the monitor when it was packaged, beneath the screen surface so as not to scratch the screen face.
This device cannot be used or installed without the Tabletop Stand or other mounting accessory. Failure to follow correct mounting procedures could result in damage to the equipment or injury to the user or installer. Product warranty does not cover damage caused by improper installation. Failure to follow these recommendations could result in voiding your warranty.
Please refer to ÒMounting on Wall or CeilingÓ section when you mount your monitor on Wall or Ceiling. See page 35.
4. To avoid falling down
Fasten the LCD monitor to wall using a cord or chain, which is sufficient to support the weight of the LCD monitor (approx. 63.0kg). The wall must be strong enough to support the monitor and mounting accessories.
500mm |
Screw Holes |
Cord or Chain 
Clamper
Screw
Before moving the LCD monitor, the cord or chain should be removed.
5.To prevent the main power switch from being changed
To prevent the ability to use the main power switch, please attach the main switch, which is enclosed as an accessory.
NOTE: With the main power switch cover in place, the main power switch cannot be turned off. Remove main power switch cover in order to switch off the display.
Screw
Main switch cover
Downloaded From
