Attaching Mounting Accessories
The display is designed for use with the VESA mounting system.
In order to aid in mounting, a lifting device must be used in conjunction with the attachable eyebolts.
1. Attach eyebolts for mounting
This model is equipped with attachable eyebolts to aid in mounting.
•Place the washer over the threads of the eyebolt.
•Screw the eyebolts into eyebolt holes as shown in the picture.
•Be sure eyebolts are secure.
•In order to move the monitor into position, use a lifting device attached to the eyebolts.
DO NOT mount the monitor using only the eyebolts.
Use an approved mounting accessory.
Eyebolt 
Washer
Eyebolt Hole
2. Attach Mounting Accessories
Be careful to avoid tipping monitor when attaching accessories. After accessories are attached, stand can be removed.
VESA Mounting Interface
Mounting accessories can be attached with the monitor in the face down position. To avoid damaging the screen face, place the protective sheet on the table underneath the LCD. The protective sheet was wrapped around the LCD in the original packaging. Make sure there is nothing on the table that can damage the monitor.
When using mounting accessories other than NEC compliant and approved, they must comply with the VESA- compatible mounting method. NEC strongly recommends using screws M8 size and 10 - 18 mm in length. If using screws longer than 18 mm, check the depth of the hole. (Recommended Fasten Force:
NEC recommends using a mounting interface that complies with UL1678 standard in North America.
3. Ventilation Requirements
When mounting in an enclosed space or recessed area, leave adequate room between the monitor and the enclosure to allow heat to disperse, as shown below.
4. Attach Mounting Accessories
The display is designed for use with the VESA mounting system.
When using mounting accessories other than NEC compliant and approved, they must comply with the VESA- compatible mounting method. NEC strongly recommends using screws M8 size and 10 - 18 mm in length. If using screws longer than 18 mm, check the depth of the hole. (Recommended Fasten Force: 1125 - 1375N•cm)
NEC recommends using a mounting interface that complies with UL1678 standard in North America.
