NEC MD213MC manual Self Calibration, English-21

Calibration

Before proper calibration can be performed, display should warm-up for a minimum of 30 minutes.

If trying to start calibration before the monitor is warmed-up, a warning will appear on the screen (Figure 1).

KEY MAP

UP/DOWN: Changes from setting to setting

LEFT/RIGHT: Changes the setting selection (ie...SELF or COPY)

SELECT: Moves to the next step of calibration

EXIT: Moves back one step of calibration

Figure 1 Figure A

NOTE: Refer to the Key Map (Figure A) when changing settings during the calibration.

Self calibration and Copy calibration can only be performed using the X-Rite i1 display2 sensor. During calibration activities and during normal operation, do not change the digital input. Always use the SAME digital input.

NOTE: With no input signal on the screen, press LEFT and RIGHT button at the same time more than 3 seconds. The CALIBRATION menu will appear.

Self Calibration

1.To show the CALIBRATION menu, plug-in the USB sensor to the sensor port (Figure 2) or select CALIBRATION in the advanced menu (page 20).

USB Sensor

Sensor Port (located at the back of the monitor)

Figure 2 Figure 3

2.Select SELF in the Mode selection (Figure 3).

3.Select the target UNIFORMITY and UNIFORMITY LEVEL. Press SELECT to go to the next section.

4.Set the target LUMINANCE (cd/m2) (Figure 4). Press SELECT to go to the next section.

5.The procedure will ask for the USB sensor to be placed on the center of the display panel (Figure 5).

Tilt the display panel approximately 5¡ backward and place the USB sensor in the center of the display panel (Figure 2).

NOTE: Place the USB sensor flat against the LCD to avoid external light contamination. DO NOT press the calibrator against the display panel.

English

Figure 4 Figure 5

English-21