NEC MT1075/MT1065 user manual Setting LAN Mode, Network Type required for wireless only

Setting LAN Mode

This feature allows you to set various setting items when the projector is used on your network.

Consult with your network administrator about these settings.

NOTE:

•A LAN card is required for LAN connection; NEC's optional wireless LAN card is available. For more information on inserting or ejecting a LAN card, see page E-30.

•Either PC Card Slots 1 or 2 can accept LAN card. If two LAN cards are in- serted into both PC card slots, the first inserted one is effective.

CAUTION: Make sure that the LAN card is removed during Standby mode (NOT Idle mode) or with the main power off.

Failure to do so may cause damage to the data on your PC card.

IP Address

An IP address can be automatically assigned to this projector by your DHCP server. If your network does not automatically assign IP address, ask your network administrator for an address, and then register it manu- ally.

Automatic	Automatically assigns an IP address to the projector
	from a DHCP server.
Manual	Provides a space for you to register the IP address or
	subnet mask number obtained from your network ad-
	ministrator.
IP Address	Set your IP address. Press to display the software
	keyboard and type in 12 numeric characters.

Subnet Mask .. Set your subnet mask number. Press to display the software keyboard and type in 12 numeric char- acters.

Projector Name Specify a unique projector name. Press to display the software keyboard and type in. Up to 16 alphanu- meric characters can be used.

Gateway ......... Set the default gateway of the network connected to

the projector. Press to display the software key- board and type in 12 numeric characters.

Checking this box will make the set default route valid. When data is sent from the LAN card, the transfer location will be searched according to the previously set routing information; however, when the transfer location has not been found as a result of the search, the data will be sent to the device that holds the IP address set here. The IP address that is set here must be one that can be identified by a search of the rout- ing information.

DNS Configuration

....................... Type in the IP address of DNS server on the network

connected to the projector. 12 numeric characters are used.

Domain Name Type in domain name of the network connected to the projector. Up to 60 alphanumeric characters can be used.

Network Type (required for wireless only)

Mode:

Select communication method when using wireless LAN.

Infrastructure	Select this option when communicating with
	one or more equipment connected to the
	wireless or wired LAN network via an ac-
	cess point.

802.11Ad Hoc .............. Select this option when using the wireless LAN to communicate with a computer in a one-to-one correspondence. This is a method that meets the IEEE802.11 wireless standard.

Ad Hoc	Select this option when using the wireless
	LAN to communicate with a computer in a
	one-to-one correspondence.
Easy Connection	This allows you to easily set up wireless LAN
	connection. See the supplied Software Util-
	ity Installation Guide for more information.

SSID (Network name):

Enter an identifier (SSID) for wireless LAN. Communication can be done only with equipment whose SSID matches SSID for your wire- less LAN. Up to 16 alphanumeric characters can be used (Case- sensitive).

NOTE: To disable SSID, select a space (null) or "ANY"(All caps).

Channel:

Set this option when selecting [802.11 Ad Hoc] or [Ad Hoc] in [Mode]. Select a channel number from the pull-down list. The channel must match for all wireless devices communicating on your wireless LAN.

NOTE: Channels in the pull-down list are different depending on which coun- try you live in.

TX rate:

Select a wireless transmission speed. Normally leave it as Automatic. Try another transmission speed when the connection fails.

E-50