Wiring Diagram

 

 

 

Monitor

 

 

 

 

 

 

 

 

 

 

 

 

 

Supplied serial cable

 

 

 

 

 

Supplied mouse adapter

Macintosh or Compatibles

 

 

 

 

 

(For Macintosh or USB)

(Desktop type or notebook type)

MOUSE REMOTE PC CONTROL OUTPUT CONTROL

INPUT

RGB MONITOR

AUDIO OUTPUT

AUDIO

RGB INPUT 1

AUDIO

RGB INPUT 2

 

S-VIDEO

L/MONO

R

VIDEO

 

Supplied mouse adapter

IBM VGA or Compatibles

(For IBM PS/2 or USB)

(Desktop type or notebook type)

 

Signal cable (supplied)

To mini D-Sub 15-pin connector on the projector. It is recommended that you use a commercially available distribution amplifier if connecting a signal cable longer than the supplied one.

DVD Player (with component output)

Optional Component V cable

To video, S-video, and audio

inputs on the projector. Document Camera

VCR, DVD Player or LaserDisc Player

NOTE: When using with a notebook PC, be sure to connect between the projector and the notebook PC before turning on the power to the notebook PC. In most cases signal cannot be output from RGB output unless the notebook PC is turned on after connecting with the projector.

NOTE: If using video, S-video, or audio cables, the cables should be 3 m (9.8 feet) or shorter.

Connecting Your PC or Macintosh Computer

Connecting your PC or Macintosh computer to your MultiSync MT1055 and MT1050 (XGA) / MT850 (SVGA) projector will enable you to project your computer’s screen image for an impressive presentation.

To connect to a PC or Macintosh, simply:

1.Turn off the power to your projector and computer.

2.Use the signal cable that’s supplied to connect your PC or Macintosh computer to the projector.

Remote Control Guideline for the Remote Control

1.Plug the supplied serial cable with the mouse output port of the pro- jector into your computer’s mouse port and restart your computer to gain remote mouse control.

2.When using the remote control’s built-in infrared mouse on a laptop computer, the laptop’s mouse, trackball or trackpad will be disabled. Disconnect the serial cable from the mouse output port and restart your computer to regain trackball or trackpad mouse control.

3.If the screen goes blank while using your remote control, it may be the result of the computer’s screen-saver or power management software.

4.If you accidentally hit the OFF button on the remote control, wait one full minute and then press the ON button to resume.

NOTE:The new Macintosh computer such as G3 will have the 15 pin HD connector. The MT1055/MT1050/MT850's "Plug and Play" data will be downloaded to the Macintosh. Therefore, the Mac adapter will not be necessary.

3.Turn on the projector and the computer.

4.If the projector goes blank after a period of inactivity, it may be caused by a screen saver installed on the computer you’ve connected to the projector.

E – 18