NEC NDA-30007-003 manual MAT Assignments, IMS Programming Manual

Conference Room Scheduler Installation Guide MAT Assignments

Chapter 4 MAT Assignments

This guide assumes that data settings that affect the operation of all OAI software on a system-wide basis have already been assigned on the NEAX Maintenance Administration Terminal (MAT). Such settings include, for instance, system index values and assignment of Interface I/O Port Data in the Interface Processor (IP). For more information about these system data settings and the MAT commands described below for Conference Room Scheduler, refer to the OAI Module Installation Manual for the NEAX2400 IMS, the NEAX2400 IMS Command

Manual, the NEAX2400 IMS Job Specification Manual, and the NEAX2400

IMS Programming Manual.

Conference Room Scheduler requires MAT assignment of the Mode Set Facility (MSF) to an OAI-assigned function key on all Dterms affected by application. This

process involves assigning the MSF and its Operation Code (Op-Code), configured for Conference Room Scheduler in the APM Application Configuration option, to one of the 14 OAI Key Codes. (The MSF Op-Codes range from 128 to 191; available for on-screen viewing through the Providers command in the APM Application Configuration option.) Each of the OAI Key Codes corresponds to an AKY1 Function Key Index (FKI) value which is then assigned to the specific Dterm function key. This process is illustrated below.

APM

Application

Configuration

Designation of

Facility (Type)

and its Op-Code

for Use by

Conference

Room Scheduler

MAT

AOKC

Command

Assignment of an OAI Key Code (between 1 and 14)

to the Same

Facility Type

and Op-Code

	PBX Correspondence of
AOKC		AKYD
	OAI	Function
Key Codes		Key Indices
1	<	> 34
2 <		> 35
3 <		> 36
4 <		> 37
5 <		> 38
6 <		> 39
7 <		> 40
8 <		> 41
9 <		> 42
10 <		> 43
11 <		> 44
12 <		> 45
13 <		> 46
14 <		> 47

MAT

AKYD

Command

Assignment of

Corresponding

MAT Function

Key Index to a

specific Dterm

Function Key

. . . . .

. .. .. .. .

. . .

Figure 4-1 OAI Function Key Assignment

A knowledge of the Dterm stations in the NEAX system and which ones will have access to Conference Room Scheduler is necessary to using the following commands:

NDA-30007 Revision 3.0 Page 13