Important Information

•Turn off the projector, unplug the power cable and have the projector serviced by qualified service personnel under the following conditions:

ƒWhen the power cable or plug is damaged or frayed.

ƒIf liquid has been spilled into the projector, or if it has been exposed to rain or water.

ƒIf the projector does not operate normally when you follow the instructions described in this user's manual.

ƒIf the projector has been dropped or the cabinet has been damaged.

ƒIf the projector exhibits a distinct change in performance, indicating a need for service.

•Disconnect the power cable and any other cables before carrying the projector.

•Turn off the projector and unplug the power cable if the projector is not to be used for an extended period of time.

•When using a LAN cable:

ƒFor safety, do not connect to the connector for peripheral device wiring that might have excessive voltage.

•Turn off the projector and unplug the power cable before cleaning the cabinet or re- placing the lamp.

CAUTION:

•Always carry your projector by using the carrying handle.

•Do not use the tilt-foot for purposes other than originally intended. Misuses such as using the tilt foot to carry or hang (from the wall or ceiling) the projec- tor can cause damage to the projector.

•Do not send the projector in the soft case by parcel delivery service or cargo shipment. The projector inside the soft case could be damaged.

•If heavy use for a number of consecutive days is expected, select the High setting in the Fan Mode window to reduce heat stress on the projector (see Fan Mode).

•Do not unplug the power cable from the wall outlet or projector when the pro- jector is powered on. Doing so can cause damage to the AC IN connector of the projector and (or) the prong plug of the power cable.

•To turn off the AC power supply when the projector is powered on, use a power strip equipped with a switch and a breaker.

•The projector can be unplugged during its cool down period after it is turned off.

•Do not try to touch the ventilation outlet on the rear as it can become heated while the projector is turned on and immediately after the projector is turned off.

•Do not turn off the AC power for 60 seconds after the lamp is turned on and while the POWER indicator is blinking green. Doing so could cause premature lamp failure.

•Do not place your hands near the lens opening while shifting the lens. Shifting the lens could pinch your fingers or hands causing injury.

vi