NEC PA271W, PA241W Remove Monitor Stand for Mounting, Flexible Arm Installation, English-8

Remove Monitor Stand for Mounting

To prepare the monitor for alternate mounting purposes:

1. Disconnect all cables.

2. Place hands on each side of the monitor and lift up to the highest position.

3.Place monitor face down on a non-abrasive surface (Figure S.1).

4.Place one hand around the base and one hand on the Quick Release Lever.

Push and hold the Quick Release Lever in the direction indicated by the arrows (Figure S.1).

5. Lift up the stand to unhook it from the monitor (Figure S.1). The monitor can now be mounted using an alternate method. Reverse process to reattach stand.

NOTE: Handle with care when removing monitor stand.

Figure S.1

Flexible Arm Installation

This LCD monitor is designed for use with a fl exible arm.

1.Follow the instructions on how Remove Monitor Stand for Mounting to remove the stand.

2.Using the 4 screws from the stand removal and attach the arm to the monitor (Figure F.1).

Caution: Use ONLY the screws (4 pcs) that are included or the screws M4 size (Length: bracket thickness + 10-12 mm) when mounting to avoid damage to the monitor and stand. To fulfi l the safety requirements the monitor must be mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor. The LCD monitor should only be used with an approved arm (e.g. GS mark).

200 mm*2 100 mm

Unit		Mounting
		Bracket
		Washer
		Screw
	10-12 mm	Thickness
		of bracket	100 mm
		and washer

NOTE: Tighten all screws.	Weight of LCD assembly: 7.4 kg (PA241W)
	9.6 kg (PA271W)
(recommended Fasten Force: 98 - 137N•cm)
	Figure F.1
*2 Only for PA271W.

English-8