NEC R 37 Xtra Part Names and Functions, Front View, Terminal Board

Part Names and Functions

Front View	Rear View

PROCEED	VIDEO 1	VIDEO 2	RGB 1	RGB 2/DTV
EXIT	▼�	�▼	�－�	＋�

POWER

/STANDBY

9 8 7 6 5 4 3 2 1

POWER

/STANDBY

1POWER ..................... Press to turn the main power on and off when the AC power is supplied.

2 POWER/STANDBY	.... When this indicator is green, the monitor is
	on; when the indicator is red, it is in standby.

3Remote Sensor Window ... Receives infrared signal from the handheld remote control.

4RGB 2/DTV/+ ............. Press to select an RGB video source that is connected to the RGB 2 input terminals (BNC type). When you are in the OSM mode, this button works as the plus button.

5RGB 1/- ......................Press to select an RGB video source that is connected to the RGB 1 input terminal (D- SUB 15 pin type).

When you are in the OSM mode, this button works as the minus button.

6VIDEO 2/ ................. Press to select an NTSC, PAL, SECAM or M-NTSC compatible video source that is connected to the VIDEO 2 input terminal

(BNC type or S-VIDEO 2 IN). When you are

VIDEO 1	VIDEO 2	RGB AUDIO	RGB 1	SPEAKER SELECT	REMOTE EXTERNAL CONTROL
				EXT SPEAKER
			RGB 2		DIP SW
			RGB 2
AUDIO	AUDIO				AC IN





0												Terminal Board
0												Terminal Board

in the OSM mode, this button works as the up button.

NOTE: S-VIDEO IN terminals will take preference over VIDEO IN terminals when the video source is connected to each terminal and VIDEO 1 or 2 selected.

7VIDEO 1/................. Press to select an NTSC, PAL, SECAM or M- NTSC compatible video source that is connected to the VIDEO 1 input terminal (BNC type or S-VIDEO 1 IN). When you are in the OSM mode, this button works as the down button.

8EXIT ........................... Press to exit the OSM mode. The OSM screen disappears.

9PROCEED ................. Press to access OSM. The OSM screen is displayed.

0Remote Control Holder..... Place remote control unit here when not in use.