NEC VT670 VT570/VT47, VT670/VT470, VT670/VT470 VT570/VT47, 3. Projecting an Image (Basic Operation), To select a menu language, follow these steps:

3. Projecting an Image (Basic Operation)Note on Startup screen (Menu Language Select screen)

When you first turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select one of the 8 menu languages.

To select a menu language, follow these steps:1.Use the SELECT ￿ or ￿ button to select one of the 8 languages for the menu.

LAMP
STATUS
POWER	VIDEO	S-VIDEO COMPUTER-1 COMPUTER-2

2. Press the ENTER button to execute the selection.

After this has been done, you can proceed to the menu opera- tion.

If you want, you can select the menu language later. See "Lan- guage" on pages 38 and 44.

SELECT

ON/STAND BY

AUTO

ADJ.

VT670/VT470 VT570/VT47

OFF		ON
	POWER
MAGNIFY	PIC-MUTE	PAGE
		UP
				SELECT
		DOWN
MENU
ENTER		EXIT		SOURCE	PIC-MUTE
		LAMP
		STATUS
		POWER	VIDEO	S-VIDEO	COMPUTER-1 COMPUTER-2
SELECT
		ON/STAND BY
					AUTO
					ADJ.
VT670/VT470			VT570/VT47
OFF		ON
	POWER
MAGNIFY	PIC-MUTE	PAGE
		UP
				SELECT
		DOWN
MENU
ENTER		EXIT		SOURCE	PIC-MUTE

NOTE: Immediately after turning on the projector, screen flicker may occur. This is not a fault. Wait 3 to 5 minutes until the lamp lighting is stabilized.

When the Lamp mode is set to Eco, the LAMP indicator will light green.

If one of the following things happens, the projector will not turn on.

•If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In this condition the projector will not turn on to protect the internal system. If this happens, wait for the projector's internal components to cool down.

•When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.

•If the lamp fails to light, and if the STATUS indicator flashes on and off in a cycle of six times, wait a full minute and then turn on the power.

24