NEC X461UN user manual Wired Remote Control Function, English-28

3.Press the “DISPLAY” button on the remote control while aiming at the “PRIMARY” monitor. The Information OSD will be shown at top left side of the screen.

Monitor ID: Displays the ID number of the current monitor within the daisy chain.

Target ID: Displays the ID number of the monitor that to be controlled via daisy chain from the current monitor.

Press the Ò+Ó or Ò-Ó buttons to change the ÒTarget IDÓ to show the ID number of the monitor to be controlled. To control the entire daisy chained monitors simultaneously, select ÒALLÓ as the ÒTarget ID.Ó

4.Use the wireless remote controller to control the “SECONDARY” monitor while aiming at the “PRIMARY” monitor. The ÒMENU OSDÓ will appear on the selected target monitor.

NOTE: If the ÒID No.Ó mode select OSD is showing, press the ÒDISPLAYÓ button on the remote control while pointing at the ÒPRIMARYÓ monitor to clear this OSD.

HINT: If you lost control due to the incorrect setting of ÒIR CONTROLÓ, pressing the ÒDISPLAYÓ button on the remote control for 5 or more seconds will reset the ÒIR CONTROLÓ menu to ÒNORMALÓ function.

WIRED REMOTE CONTROL FUNCTION

You can control this monitor by connecting REMOTE IN/OUT with Stereo Mini plug cable (3.5 ).

MultiSync MultiSync

Remote IN Remote OUT Remote IN Remote OUT

INOUT

MultiSync

Remote control cable Remote control cable

NOTE: Turn off the main power switch before connect/disconnect Stereo Mini plug cable.

English-28